Vutec LECTRIC IV - Installation Instructions Manual de usuario

Installation Instructions Lectric IIe & IVe FLUSH CEILING MOUNT SCREEN FULL TRAP DOOR CLOSURE 02/20/08 Rev. D LIIe-INSTL_D

9 04/21/08 Rev D LIIe-INST_D SCREEN ROLLER ASSEMBLY REMOVAL PRIOR TO INSTALLATION Support the unit from under end cap flanges (Figure 7) and cle

10 04/21/08 Rev D LIIe-INST_D Figure 8 Cut out of housing and end cap removed to illustrate details Figure 9 Housing components remov

11 04/21/08 Rev D LIIe-INST_D TROUBLESHOOTING SYMPTOM CAUSE SOLUTION Door remains closed and screen will not come down. Motor does not hum.

1 04/21/08 Rev D LIIe-INST_D IMPORTANT SAFETY INSTRUCTIONS Basic safety precautions should always be followed; including the following: ♠ Rea

2 04/21/08 Rev D LIIe-INST_D LECTRIC IIe & IVe FLUSH CEILING MOUNT WITH TRAP DOOR SELF-SUPPORTED (shown) and TAB-TENSIONED screens F

3 04/21/08 Rev D LIIe-INST_D HOUSING INSTALLATION Lectric IIe (Self-supporting fabric) and Lectric IVe (Tab-tensioned fabric) are designed for

4 04/21/08 Rev D LIIe-INST_D If the unit was shipped complete with the screen roller assem bly installed; proceed to SCREEN ROLLER ASSEMBLY R

5 04/21/08 Rev D LIIe-INST_D ELECTRICAL CONNECTIONS If the unit was shipped com plete with the m otor and ro ller assem bly inside; then there

6 04/21/08 Rev D LIIe-INST_D WIRING DIAGRAM - 120VAC The screen may also be operated by optional IR/RF remote control, optional 12VDC trigger r

7 04/21/08 Rev D LIIe-INST_D Figure 5a Figure 5b UPPER LIMIT ADJUSTMENT The upper lim it for the screen is when the trap door closes

8 04/21/08 Rev D LIIe-INST_D Send the screen down to the lower limit and it should stop automatically. Return the control switch to center off p