Vutec SIK232 Interface - Instructions Manual de usuario Pagina 1

1 / 13

10 / 13 55.. AAss aa PPrrooggrraammmmiinngg DDeevviiccee Before attempting to program any devices using the R2D7, read and understand the secti

11 / 13 66.. AAppppeennddiixx AA:: SSppeecciiffiiccaattiioonnss 6.1. RS-232 Port Pin Configuration When looking at the face of the R2D7, the RS

12 / 13 77.. AAppppeennddiixx BB:: QQuuiicckk RReeffeerreennccee 7.1. Port Settings Port Speed 9600 baud Data Bits 8 Parity None Stop Bits

13 / 13 88.. AAppppeennddiixx CC:: EExxaammpplleess 8.1. Standard Examples Open Motor 3 on System 7 *7o03; Close Group 27 on System 5 *5c27;

2 / 13 1. Introduction ... 3 2. Installatio

3 / 13 11.. IInnttrroodduuccttiioonn The world of home automation and integration has been growing at an enormous rate in recent years. Control h

4 / 13 22.. IInnssttaallllaattiioonn 2.1. Providing a Power Source A power source must be provided to the R2D7 on system 1. This source may be

5 / 13 2.3. Adding Hardwired Systems When going from system ports other than system 1 on the R2D7, the connection may go to either an “EYE” or an “

6 / 13 33.. RR22DD77 PPrroottooccooll Communication with the R2D7 is defined in two parts: command strings and response strings. 3.1. Command St

7 / 13 3.1.2. Configuration Strings Configuration strings for the R2D7 are segmented into 3 parts: * V ; As with operating instructions, the fir

8 / 13 44.. OOppeerraattiinngg MMooddee –– SSyysstteemm 77 By default, system 7 is configured for radio mode. 4.1. Radio Mode As previously m

9 / 13 In our example from the previous section, we identified systems 12, 13, and 14. So, if we wanted to close all motors on system 13, we would